Pioneer GM-ME500X1 Marine monoblock amplifier

Big bass at sea

It takes a lot of amplifier power for your bass notes to be heard clearly over the sounds of the waves, wind, and engine noise. Pioneer's ME-Series GM-ME500X1 mono marine subwoofer amplifier can put out up to 800 watts RMS, enough for everyone in and around your boat to feel the beat.

Pioneer's ME-Series sweetness

This amplifier's output power matches up nicely with Pioneer's ME-Series TS-ME100WS and TS-ME100WC marine subwoofers, allowing you to build up a large system by adding one sub at a time. When running one sub, the amp puts out 300 watts RMS, exactly the power rating of the sub. With two subs, the amp sends out 500 watts RMS total, 250 watts to each sub. With three of them, it delivers about 700 watts RMS, about 233 watts per sub. And with four, it produces a whopping 800 watts RMS, 200 per sub. Not bad for one little amp.

More info

The GM-ME500X1 features a low-pass and a subsonic filter to tune the bass tones to match your subs and make them sound good. Conformal coated circuit boards and rubber connection/control covers keep water and dirt away from sensitive areas.

Product highlights:

mono marine subwoofer amplifier
300 watts RMS x 1 at 4 ohms
500 watts RMS x 1 at 2 ohms
800 watts RMS x 1 at 1 ohm
CTA-2006 compliant
frequency response: 10-240 Hz
variable low-pass filter (40-240 Hz, 12 dB/octave)
selectable subsonic filter (30 Hz, 24 dB/octave)
Other Features:

conformal coated circuit boards
rubber covers protect side panel controls, RCA terminals, and fuses
preamp and speaker-level inputs
wiring and hardware not included with amplifier
4-gauge power and ground leads recommended
fuse rating: 40A x 2
dimensions: 10-3/4"W x 2-7/16"H x 8-7/16"D
warranty: 1 year